Materials Science
Mostafa M. Ibrahim; Mustafa A. Hassan; Khaleel I. Hassoon
Abstract
In this work, the physical properties of iron sulfide (FeS2) thin films deposited by the chemical spray-pyrolysis (CSP) technique were studied. The thin films are deposited on glass substrates at 200oC, using FeCl3 salt with thiourea (NH2)2CS as precursors. Structural analysis of X-Ray diffraction ...
Read More ...
In this work, the physical properties of iron sulfide (FeS2) thin films deposited by the chemical spray-pyrolysis (CSP) technique were studied. The thin films are deposited on glass substrates at 200oC, using FeCl3 salt with thiourea (NH2)2CS as precursors. Structural analysis of X-Ray diffraction manifested that the thin films contain two phases: Marcasite and Pyrite in planes (110), (111) at angles 2θ =26.3°, 2θ =28.3° respectively. Optical properties analysis showed that the prepared iron sulfide thin-films were highly absorbing in the UV-Visible range and the absorption coefficient was in the range of 1.6x105 cm-1 with a relatively low resistivity of about 0.49 (Ω.cm). The calculated activation energy (Ea) was 0.024 eV and the bandgap value was 2.45 eV. Moreover, the FeS2 thin films were also deposited on (CdO) to fabricate a heterojunction photocell. In conclusion, there is the feasibility of preparing low-cost and highly absorbing iron sulfide (FeS2) thin films for optoelectronic applications with acceptable homogeneity using the spray-pyrolysis technique.
Nanotechnology
Saja H. Salim; Riyad H. Al-Anbari; Adawiya Haider
Abstract
Due to low water fluxes, commercial ultrafiltration (UF) membranes used in water treatment need to be improved. High-quality UF membranes were fabricated from polysulfone (PSF)/titanium dioxide (TiO2) nanocomposite fibers as substrates using the spray pyrolysis method. The influence of nano-TiO2 on the ...
Read More ...
Due to low water fluxes, commercial ultrafiltration (UF) membranes used in water treatment need to be improved. High-quality UF membranes were fabricated from polysulfone (PSF)/titanium dioxide (TiO2) nanocomposite fibers as substrates using the spray pyrolysis method. The influence of nano-TiO2 on the UF nanocomposite membrane was studied. Scanning electron microscopy (SEM), contact angle, and porosity were evaluated to characterize the mechanical characteristics of the membranes. The results show that adding TiO2 to the substrates increased the hydrophilicity and porosity of the substrates. The pure water flux of the Thin Film Nanocomposite (TFN) membrane manufactured utilizing a PSF substrate coated with 0.1 wt% TiO2 nanoparticles (denoted as Pc 0.1) improved at a rate of 35.28 l/m2.h, and for a PSF substrate coated with 0.2 wt% TiO2 nanoparticles (denoted as Pc 0.2) improved at a rate of 44 l/m2.h. Additionally, increasing TiO2 nanoparticle loading to 0.1 and 0.2 wt. percent resulted in higher water flow over 20 l/m2.h PSF commercial membrane. The results of the UF performance show that Pc 0.2 membrane offered the most promising results, with a high-water flux than commercial membranes without nano-TiO2 (Pc).